The OneDer SQUARE TM

THE ULTIMATE COMBINATION CROSSCUT SAW GUIDE / SQUARE / LEVEL

The only crosscut saw guide that shows your saw where to cut!

 

the ulitmate crosscut saw guide.

 

The newest feature of The OneDer Square TM

is The OneDer Bridge TM .

 

To cut I-joists with your worm drive saw just snap The OneDer Bridge TM into The OneDer Square TM . The pointer still shows your saw where to cut.



 


 

 
 


 

  

Set The OneDer Square TM according to the instructions. To cut an I-joist insert The OneDer Bridge TM into The OneDer Square TM , place the square with the pointer on your measured mark, then just use your normal saw to cut the I-joist. Your saw will ride the bridge when it gets to the center of the I-joist. Just like your OneDer Square TM , The OneDer Bridge TM is reversible and can be snapped into both sides of your OneDer Square TM so you can use it on either side of your saw.


 
  

Just remove the OneDer Bridge TM from The OneDer Square TM to cut standard lumber.

  
  
I-joist   

The bridge can also be used to draw circles on the job site. The holes are 3" through 7", and designed to be used with a construction pencil.

   
I joist  

Lightly hammer a nail into the hole closest to the end, and use the marked hole for the size you want.

  

 

Click Here

Click Here

Click Here

Click Here

Click Here

Click Here

TO RETURN TO THE TOP OF THE PAGE

click here